2010 Toyota Sequoia
Mileage
64,213
Service Date
4/23/2024
Services Performed
- General Inspection – Priority List – Priority One 1. Replace battery Priority Two 1. Diag code P2443 Priority Three 1. Retorque driveshaft bolts 2. Tighten chassis, body nuts and bolts. Inspection Findings – Oil Change & Filter – Preforming oil change at this time SEL- Code list – Current codes, P2443 secondary air injection system switching valves stuck closed bank two. B1424 solar sensor circuit driver side. B1421 solar sensor circuit passenger side. B2795 not matched key code. C2121 transmitter ID one not received main. C2174 vehicle speed signal error. Recommend to diag current codes Tire Rotation – Preforming tire rotation at this time Battery Condition – Battery is rated for 885 CCA and tested back at 611CCA recommend to replace battery Tire pressure & condition – Found front tires to have some inside tire wear, all tires at 36 psi, found passenger side rear tire valve core is leaking air replacing at this time By time and / or mileage – OEM recommendations based by mileage 1. Replace engine oil and filter 2. Retorque drive shaft bolts 3. Rotate tires 4. Tighten chassis body nuts and bolts.
- Current codes, P2443 secondary air injection system switching valves stuck closed bank two. Recommending further diag.
- Preformed oil change, replaced oil filter, filled vehicle up with 8 quarts of 0w20 with MOA, started vehicle and checked oil level and wrote new sticker and reset oil life, next oil change service at 69,213.
- Tire condition – Found inside tire wear on tires Tire DOT date – Tires are from 2015 recommend tire shop for repairs Tire pressure – Tires are at 36 psi Front brake pads – Condition (Visual) Front pads are at 8mm in the green Rear brake pads – Condition (Visual) Rear pads are at 8mm in the green Wheel torque – Torque the wheels down to 97 foot pounds Tech Notes – Front and rear pads and rotors look good, tires do have some inside tire wear see aliment work order. When adjusting tire pressure found issues with one schrader valve leaking, installed new schrader valve and verified now more leaks.
- Performed steering and suspension inspection, found all component in good operation. Performed alignment, adjusted toe, road tested to verify vehicle tracking true to the road.
- Per previous recommendation. Removed old worn battery and replaced with new interstate battery. MTP27f. Added battery protectant to terminals.
- Scanned code and found code P2443 for stuck closed air injection valve on bank 2, tested powers and grounds at driver both bank 1 and bank 2, preformed resistance, testing and found resistance inspect on both valves, confirming not to be a circuit fault. Using power probe, to turn valve on and open them and found valve 1 is working but when sending power to pump 2 found that valve wasn’t opening. recommending replacing both secondary air valve with new pumps.
Linda P. gave our service a 5 star review on 4/23/2024
