2007 Jeep Liberty
Mileage
153,641
Service Date
11/6/2023
Services Performed
- Scanned vehicle for codes, P0305 preset, check and verified ignition misfire on cylinder #5, inspected ignition components and verified ignition coil fault, also found spark plugs are worn. Recommending performing ignition tune up including spark plugs and ignition coils.
- During vehicle inspection found: Priority One: 1. Remove transfer case bolt to check fluid level/ reseal 2. Brake inspection 3. Oil Change Priority Two: 1. Battery terminal service 2. Front axle seals 3. Drive Shaft boot, 4. Diag codes Priority Three: 1. Power Steering Flush, 2. License Plate Bulb Oil Change & Filter: Oil change is needed, car is 8,000 miles over due for an oil change based off sticker in windshield SEL- Code list: Codes that came back after test drive, C2102, C1032, C102B, and U1418 Cabin air filter: NA Lights (Head, Brake, Turn): License plate light is out Engine Oil: Engine oil is worn recommend replacing Power Steering Fluid: Power steering fluid is worn recommend BG service Battery Condition: Battery tested good but recommend battery terminal service Brakes (Pads/Shoes): Front pads are low and front brake rotors have groves recommend brake inspection Driveline (Axles / CV Shafts): Front driveline boot is ripped and causing play recommend to replace front drive line Transfer Case fluid: Transfer case has very bad leak from bottom of seal recommend to re seal, could not get transfer case bolt due to it being stripped out, to check fluid level would have to extract bolt Under vehicle fluid leaks: Front axle seals are leaking recommend replacing seals
- Removed & replaced Ignition Coil. Road tested to verify repairs, no misfire codes returned after test drive.
Emily W. gave our service a 5 star review on 11/7/2023
